H Disabling Autorate; H Resetting Autorate - Paradyne 7974 User Manual

Initial Startup and Configuration
Disabling AutoRate
Î Î
"
Resetting AutoRate
3-16
The M/SDSL AutoRate function is controlled from the Network Interface Options
screen and allows you to enable or disable AutoRate. The AutoRate option is
only available if the unit is configured as an LTU. To access the Network Interface
screen, follow this menu selection sequence:
Main Menu Configuration
main/config/network
Port Status
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate:
DSL Line Rate:
EIA-530 Payload Rate
Transmit Attenuation
Peer IP Address:
Circuit Identifier:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Procedure
The AutoRate option defaults to Enable. To disable AutoRate:
1. Position the cursor in the AutoRate field and press the spacebar.
The AutoRate field toggles to Disable and the DSL Line Rate field appears.
2. Enter a DSL Line Rate and press Enter.
The Reset AutoRate function of the Control branch causes the unit to repeat the
AutoRate sequence. The unit attempts to establish the DSL link at the highest
rate (or the value of DSL Line Rate, which represents the AutoRate ceiling when
AutoRate is enabled). If the link fails, the next lower rate is tried until the link is
established.
To access the Reset AutoRate screen, follow this menu selection sequence:
Main Menu Control
August 2000
Network
NETWORK INTERFACE OPTIONS
Reset AutoRate
Hotwire
Model: 797x
Enable
–3db
1E–5
Disable
1552 kbps
1536 kbps
0dB
111.255.255.000 Clear
Î Î Î Î
Clear
MainMenu Exit
7900-A2-GB21-00