Throttle Release Switch; Brake Switch; Perc Switch - Polaris 600 RUSH 2010 Manual

Battery and Electrical Systems

Throttle Release Switch

The throttle release switch is integrated into the right
hand throttle control block. The switch provides a
software stop signal to the ECU.
A software stop is used to determine the position of the
throttle release switch. The software stop system is
activated when the throttle release switch is closed
(closed throttle), but the TPS (throttle plate position) is still
above idle. When this occurs, the ECU will determine the
throttle cable is "stuck" and disable the ignition system.
Throttle Release Switch Testing
BK/BLU
PUSHED
RELEASED

Brake Switch

The brake switch is integrated into the brake lever
assembly. When the brake lever is pulled, the switch
closes. The closed switch completes the brake signal to
the ECU and rear brake LEDs. The ECU signals the
instrument cluster to illuminate the brake icon.
Brake Switch Continuity
PUSHED
RELEASED
10.32
BK/RED
PIN 1 PIN 2
6790 +/- 185
2148 +/- 185
RED ORG/BLK
X X

PERC Switch

There are two types of Polaris Electronic Reverse Control
(PERC) switches used on PRO-RIDE snowmobiles, but
both function the same. Type one is integrated into the left
hand control block and is not serviceable. The type two
switch is mounted to the handlebar.
When pushed, the reverse command signal is sent to the
ECU. The ECU uses the signal to engage reverse engine
control.
PERC Switch Continuity
LH CNTRL EE
PUSHED
RELEASED
TYPE 2 SWITCH
PIN 1 PIN 2
OR OR
LH CNTRL FF
X X