Electronic Reverse (Perc); Overview; Operation; Forward Operation - Polaris 600 RUSH 2010 Manual

Cleanfire Fuel Injection

ELECTRONIC REVERSE (PERC)

Overview

The operation of the electronic reverse system is achieved
by automatically reversing the engine rotation with a push
of a button. When in reverse, an indicator light will flash,
indicating the engine is in the reverse mode. The design
of the clutches is matched to the specifications that will
allow the backwards rotation of the engine to move the
sled in reverse. Getting back to forward is as easy as
pushing the button again.

Operation

WARNING
Reverse operation, even at low speeds, may cause
loss of control, resulting in serious injury or death. To
avoid loss of control, always:
LOOK BEHIND BEFORE AND WHILE BACKING.
AVOID SHARP TURNS.
SHIFT TO OR FROM REVERSE ONLY WHEN
STOPPED.
APPLY THROTTLE SLOWLY.
CAUTION
To avoid personal injury and/or engine damage, do not
operate the electric start or recoil while engine is
running.
1. Ensure that the vehicle is stopped and the engine is
warmed up and running at idle.
NOTE: The system will only engage in reverse if the
engine is below 4000 RPM. If engine is above 4000
RPM the system cannot be activated.
2. Ensure that the path behind you is clear.
3. Push and hold the yellow reverse button on the left
hand control for 1 second and then release the button.
The reverse light on the instrument panel will flash
when engine is in reverse motion.
NOTE: The engine will automatically reduce RPM
and it will reverse the rotation of the engine when the
RPM is at the lowest RPM point.
4. Ensure that the path behind you is clear.
5. Slowly apply throttle until the sled starts to move in
reverse, and carefully direct the sled in the direction
that you want.
4.52
NOTE: Maximum RPM in reverse is 6000 RPM.
NOTE: If the engine stops running or is shut off
while in reverse. The engine will start in forward
gear.

FORWARD OPERATION

1. If unit was operated in reverse, ensure that the path
ahead is clear, and push and hold the reverse button
for 1 second and then release the button. The engine
will now automatically change direction form reverse
to forward and the reverse light on the instrument
panel will stop flashing.
NOTE: When servicing clutches, ensure that the
vehicle is in forward gear. If not damage to the
driven clutch may occur when removing the belt.