Changing Units; Fuel Selector; Analog/Digital Ic Error Code Display - Polaris 600 RUSH 2010 Manual

Battery and Electrical Systems

Changing Units

The instrument cluster will display either standard or
metric units. Change between the two by following these
steps:
1. Press and release the MODE button on the cluster or
left hand control to display the engine temperature on
the rider information screen.
2. While in the engine temperature display, press and
hold the MODE button to change units.

Fuel Selector

1. Start the engine.
2. Lock the parking brake.
3. Press and release the MODE button on the left
handlebar control until either "ETH" or "91--NON" is
displayed on the instrument cluster.
4. Press and hold the MODE button on the left handlebar
control to change between fuel settings.
10.10

Analog/Digital IC Error Code Display

Active diagnostic trouble codes can be reviewed by
accessing the instrument cluster's diagnostic display
mode.
The diagnostic display mode is accessible when a trouble
code is active (MIL illuminated) and when the engine is
running.
1. Keep the engine running, and set the parking brake.
2. With the engine running and the MIL illuminated,
press and release the MODE button to toggle to the
diagnostic display mode. If an error code exists, two
numbers will appear in the display and the MIL will
flash.
3. A set of two numbers will appear in the display.
• The 2-6 digit suspect parameter number (SPN) in
the information display area indicates which
component is generating the fault code.
• The 1-2 digit failure mode indicator (FMI) number
in the odometer area indicate the fault mode, such
as open or short circuit.
SPN =
FMI =
4. More than one fault may be active. Press and hold the
MODE button or MODE switch for two seconds to
toggle to the next active code. Repeat until all codes
are retrieved.
5. Press and release the MODE button to exit this mode.
NOTE: "SPN=" and "FMI=" are not displayed on
screen.