Drive Belt Removal - Spa P2; Drive Belt Installation - Spa P2; Adjusting Belt Deflection - Spa P2 - Polaris 600 RUSH 2010 Manual

Table of Contents

Drive Belt Removal - SPA P2

THREADED HOLES

NOTE: Turn the key to the "OFF" position and allow

the engine to come to a complete stop.

1. Verify the driven clutch is not in reverse. Open the LH

compartment door panel.

Damage to the driven clutch or L wrench will occur when

attempting to open the driven clutch when the driven

clutch is in the reverse position.

2. Insert the L wrench, PN 2874857, into one of the

threaded holes located on the driven clutch. Turn it

clockwise until the clutch sheaves are in the open

3. Remove the drive belt.

1. With the L wrench inserted into one of the threaded

holes and the sheaves in the open position, install the

NOTE: Install belt so that the numbers can be read

correctly on the left side of the machine or in the

direction in which the belt was originally installed.

2. Remove the wrench. "Wiggle" the belt to remove slack

while removing the wrench.

1. Loosen the deflection screw jam nut.

2. Using a 1/8 Allen driver, turn the deflection screw in

or out to adjust the distance between the driven clutch

3. When the proper belt deflection is achieved torque the

lock nut to specification.

Deflection Screw Lock Nut: 110 in-lbs (12 Nm)

DEFLECTION SCREW

Table of Contents