Table of Contents
Advertisement
TCD Analyzer
Operation
4.1 Introduction
Although the Analyzer is usually programmed to your application at
the factory, it can be further configured at the operator level, or even,
cautiously, reprogrammed. Depending on the specifics of the
application, this might include all or a subset of the following
procedures:
Setting system parameters:
o Establish a security password, if desired, requiring Operator
to log in.
o Establish and start an automatic calibration cycle, if desired.
Routine Operation:
o Calibrate the instrument.
o Choose auto ranging or select a fixed range of analysis.
o Set alarm setpoints, and modes of alarm operation (latching,
failsafe, etc).
Program/Reprogram the analyzer:
o Define new applications.
o Linearize your ranges.
If you choose not to use password protection, the default password
is TETAI, and you simply can access to all functions of the analyzer
except for Application and Logarithm.
Teledyne Analytical Instruments
Operation
27
Advertisement
Table of Contents
