Front Panel Messages; Indicators; Messages - Tektronix Phaser 750 User Manual

Front panel messages

Indicators

Symptom Possible Causes
Power indicator is
I
blinking
I
Power indicator is off The printer is turned off, is not
ready, is disabled, or has
detected an error.
Error indicator is on Attention is required, but not
immediately. For example,
when the front panel reads
<color>:low.
Error indicator is
I
blinking
I
I
The front panel menu Front-panel timeout: If no
exits and returns to activity occurs in 5 minutes, the
Ready without front panel returns to Ready.
anyone pressing the
button.

Messages

Jam at <Location>
Possible Causes
Media jam.
Too much media is loaded in
the media tray.
Media is wrinkled or curled.
Media is too thick or too thin.
Advanced Features and Troubleshooting Manual
The printer is receiving,
processing or printing a job.
You have entered the menu in
the front panel.
The printer is stopped
because it detected a
user-correctable error such as
an open door or a media jam.
Error occurred that may be
user-correctable.
Error occurred that is not
user-correctable.
Solution
To find the jam: See the front panel message. Also, refer to the
I
illustration on the inside front door.
To clear the jam: Refer to the printer's User Guide.
I
Make sure that paper or transparencies are installed correctly
I
and in the media-specific tray. See the user guide for details
on loading media.
To prevent a jam: Clean the rollers. See page 156 for details on
I
cleaning.
Reduce the amount of media to below the media level indicator
on the media tray label.
Change the media.
Use recommended media.
For media loaded in the Multi-Purpose Tray, make sure that you
have set the Media Thickness Switch on the printer to
accommodate thick, medium, or thin media.
Troubleshooting Phaser 750 Printers
Solution
Wait for the job to be completed or
I
cancel the job.
Exit the menu.
I
Make sure that the printer is turned on.
Read the front panel message to
determine the printer's status.
Correct the condition reported by the
front panel.
Correct the condition reported by the
I
front panel (for example, close the
door or clear the media jam).
Press the Info/More button to access
I
information on the error condition.
Read the front panel message. If the
I
message includes an error number,
find that number listed in Error codes
on page 148 and follow any
directions there for recovery.
Press Menu to re-enter the menu.
117