Tektronix Phaser 750 User Manual page 129

The page is blank
I Remove and re-insert the Imaging Unit.
I Turn the printer off and back on again.
Horizontal stripes
I Thin horizontal stripes or a "weave" pattern appears in a complex image.
I Increase the amount of memory.
I Print the image at a lower resolution.
Prints have dull, faded colors
I
If you are using a media tray, make sure that you have loaded the correct media in the
tray or
PAPER TRANSPARENCY
I If you are using the Multi-Purpose Tray, make sure that you have selected the correct
media type in the printer's front panel.
I Print the Color Reference Page from the front panel's Calibrate Colors menu. Check
the density settings for each color and compare them to the examples on the Color
Density Samples card. (in the User Guide).
I
Print the Consumables Page and Diagnotic Test Pages from the front panel's Help
Pages.
If all colors are faded on the Test Print, the Imaging Unit may need to be
I
replaced. Refer to the Percent Remaining gauge for the Imaging Unit on the
Consumables Page.
If one color is faded (and you have checked and/or adjusted the density setting
I
for that color), replace the Toner Cartridge.
I
Make sure that the Imaging Unit stays covered until immediately before installing it
in the printer. Exposure to light can damage the Imaging Unit and will produce light
streaks or faded prints.
I Remove and insert the Toner Cartridges to make sure they are installed correctly.
I Make sure that you use a high-quality laser paper: 60 - 90 g/m
the media trays and 163 g/m
results use Tektronix media.
I
Use only Tektronix transparencies. Tektronix does not guarantee the results of
non-Tektronix transparencies in Tektronix printers.
I Try a different color correction mode.
Advanced Features and Troubleshooting Manual
Troubleshooting Phaser 750 Printers
tray.
2
(40 lb.) paper with the Multi-Purpose Tray. For best
2
(16 - 24 lb.) paper in
129