Configuring The Setting Parameters - Omron NXR Series User Manual

7-4

Configuring the Setting Parameters

This section describes how to configure the Setting Parameters of the IO-Link Master Unit with the
Sysmac Studio.
Configuring the Setting Parameters of the IO-Link Master Unit with
the Sysmac Studio
1
Open the project for the Controller in the Sysmac Studio.
2
Right-click EtherCAT in the Multiview Explorer and select Edit from the menu.
3
In the EtherCAT tab page, select the IO-Link Master Unit and click the Edit Setting
Parameters button.
The Edit Setting Parameters tab page is displayed.
This setting affects the parameter that is automatically set by the EtherCAT master when Ether-
CAT communications start or when a slave is reconnected.
The setting parameter for the IO-Link Master Unit is the following CoE object.
Subin-
Index
dex Object name
(hex)
(hex)
10F3 05 Flags
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)
Default Data range
0000 hex 0000 hex, 0001
hex
7 Setting Up IO-Link Master Unit
Data
at-
Unit Size
trib-
ute
--- Ena- 2 bytes
bled (U16)
at all
times
PDO
Ac-
map-
cess
ping
7
RW Not
possi-
ble
7-21