Setting The Device Parameters Of The Io-Link Master Unit - Omron NXR Series User Manual

Setting
Offset Setting of Port£ Digital Input
Data Collection
Session Timeout
7-2-2

Setting the Device Parameters of the IO-Link Master Unit

This section describes how to set the device parameters of the IO-Link Master Unit using the Backup
Parameter Settings with the Sysmac Studio.
This setting method allows you to set all device parameter items.
1
Open the project for the Controller in the Sysmac Studio.
2
Right-click EtherCAT in the Multiview Explorer and select Edit from the menu.
3
In the EtherCAT tab page, select the IO-Link Master Unit and click the Edit Backup Parameter
Settings button.
4
Set each item in the Edit Backup Parameter Settings tab page.
In addition, using the IO-Link Master Simple Settings in the Sysmac Studio enables you to configure
device parameter settings other than Session Timeout. In particular, you can easily configure the fol-
lowing IO-Link device information.
• Device ID
• Vendor ID
• IO-Link Revision
• Process Data In Length
• Process Data Out Length
• Port£ Serial Number Configuration Data
Refer to A-4 IO-Link Master Simple Settings on page A-59 for information on the setting procedures
with the IO-Link Master Simple Settings.
NXR-series IO-Link Master Unit for EtherCAT User's Manual (W640)
Description
Specify the position of the bit to ex-
tract from IO-Link Input Data.
Set the status (Success or Error) hold
time for messages for IO-Link devi-
ces.
7 Setting Up IO-Link Master Unit
Update
Reference
timing
9-7 Digital Input Collection on
page 9-15
Enabled A-1-8 Manufacturer-specific
at all Object 2 on page A-23
times
7
7-5