Safety Regulations - Ariston 801 Instructions For Installation, Use, Maintenance

SAFETY REGULATIONS

Key to symbols:
Failure to comply with this warning im-
plies the risk of personal injury, in some cir-
cumstances even fatal.
The unit contains R290 flammable gas.
Failure to comply with the warning implies the
risk of fire and/or explosions.
Failure to comply with this warning may
result in serious damage to property, plants
or animals. The manufacturer is not liable for
damage resulting from improper use of the
product or failure to install it as instructed
herein.
The appliance must be placed in a room
without ignition sources operating continu-
ously (open flames, an operating gas-fired
appliance, or an operating electric heater)
Risk of fire and/or explosion.
Never use equipment other than that rec-
ommended by the manufacturer to speed
up defrosting or for cleaning purposes.
Risk of fire and/or explosion.
Do not perforate or burn the appliance.
Risk of fire and/or explosion.
The R290 refrigerant (propane) is a flam-
mable and odourless refrigerant.
Risk of fire and/or explosion.
It is forbidden to perform repair work on
the cooling circuit and on the components
belonging entirely to it at the installation
site. These interventions may be carried
out only at a workshop that is suitably
equipped for servicing units with flamma-
ble refrigerants and by qualified person-
nel. Annex HH IEC 60335-2-40.
Risk of fire and/or explosion.
The refrigerant charging operations may
only be carried out by qualified personnel
with adequate equipment. Annex HH IEC
60335-2-40.
Risk of fire and/or explosion.
The water heater is supplied with 0.15 kg
of R290 refrigerant. Do not exceed the al-
lowed charge quantity.
26 / EN
Risk of fire and/or explosion.
Maintenance operations or repairs may
only be carried out by qualified personnel
with the appropriate Personnel Certification
certifying their knowledge of and ability to
manage plants containing HC-type gases
such as R290 (propane), and with adequate
equipment.
Risk of fire and/or explosion.
Install the appliance on a solid basement
which is not subject to vibration.
Noisiness during operation.
When drilling holes in the wall for instal-
lation purposes, take care not to damage
any electrical wiring or existing piping.
Electrocution caused by contact with live
wires.
Damage to existing installations.
Flooding caused by water leaking from dam-
aged pipes.
Perform all electrical connections using
wires which have a suitable section. The
connection product must be carried out
following the instructions provided in the
relative paragraph.
Fire caused by overheating due to electrical
current passing through undersized cables.
Protect all connection pipes and wires in or-
der to prevent them from being damaged.
Electrocution caused by contact with live
wires.
Flooding caused by water leaking from dam-
aged
piping.
Make sure the installation site and any sys-
tems to which the appliance must be con-
nected comply with the applicable norms
in force.
Electrocution caused by contact with live
wires which have been installed incorrectly.
Damage to the appliance caused by improp-
er operating conditions.
Use manual tools and equipment that are
suitable for the intended use (in particular,
ensure that the tool is not worn and that
the handle is intact and securely fixed);
use them correctly and prevent them fall-
ing from a height. Put them safely back in
place after use.