Flats On Shafts - Dürkopp Adler D869 e-con Service Instructions Manual

2. Press Next.
 The software is used to define the necessary presettings on
3. Press the Service Stop button.
Important
The maximum permissible stitch length can be set in the service routine.
4. Disassemble the throat plate ( p. 29).
5. Pull off the cover.
6. Loosen the screw (2).
7. Remove the feed dog (1) upwards.
Assembling the feed dog
To assemble the feed dog on 2-needle machines:
1. Place the feed dog (1).
2. Tighten the screw (2).
3. Insert the throat plate ( p. 29).
4. Finish the service routine.
5. If necessary, adjust the feed dog height ( p. 49).
3.6
Fig. 23: Flats on shafts
(1) - Flat
Some shafts have flat surfaces at the points where the components are
screwed on. This stabilizes the connection and makes adjusting easier.
32
the machine.

Flats on shafts

NOTICE
Property damage may occur!
An incorrect setting can result in damage to the machine.
Always place the first screw in rotational direction onto the flat.
①
②
(2) - Shaft
Service Instructions D869 e-con - 00.0 - 09/2023
Working basis