Buell S1 Lightning 1996 Manual page 62

GENERAL
Check wheels for lateral and radial runout before installing a
new tire.
Rim Lateral Runout
1. See Figure 2-11. Install truing arbor in wheel hub and
place wheel in WHEEL TRUING AND BALANCING
STAND (Part No. HD-99500-80).
2. Tighten arbor nuts so hub will turn on its bearings.
3. Check rim lateral runout by placing a gauge rod or dial
indicator near the rim bead. Replace wheel if lateral
runout exceeds specification shown in
Rim Radial Runout
1. See Figure 2-12. Install truing arbor in wheel hub and
place wheel in WHEEL TRUING AND BALANCING
STAND (Part No. HD-99500-80).
2. Tighten arbor nuts so hub will turn on its bearings.
3. Check radial runout as shown. Replace wheel if runout
exceeds specification shown in
Table 2-4. Wheel Runout
MAXIMUM
WHEEL TYPE LATERAL
RUNOUT
Cast Marchesini 0.040 in.
(1.02 mm)
Aluminum P/M 0.020 in.
(0.51 mm)
2-14
CHECKING CAST RIM RUNOUT
Table 2-4.
Table 2-4.
MAXIMUM
RADIAL
RUNOUT
0.030 in.
(0.76 mm)
0.020 in.
(0.51 mm)
www.PlanDeGraissage.org
f1378x2x
Wheel Truing and Balancing
Stand (Part No. HD-99500-80)
Figure 2-11. Checking Cast Rim Lateral Runout
f1379x2x
Wheel Truing and Balancing
Stand (Part No. HD-99500-80)
Figure 2-12. Checking Cast Rim Radial Runout
Gauge rod
Gauge rod