Buell S1 Lightning 1996 Manual page 245

e. See Figure 6-46. If lockplate will not align with holes,
tighten nut to 45 maximum.
CAUTION
Maximum allowable tightening of sprocket nut is 45 of
counterclockwise rotation, after initially tightening to 50 ft-
lbs. Do not loosen sprocket nut while attempting to align
the screw holes. If you cannot align lockplate and sprocket
screw holes, nut may be additionally tightened 45 as
specified above. Tightening too much or too little may
cause the nut to come loose during vehicle operation.
12. If you cannot align lockplate and sprocket screw holes,
nut may be additionally tightened until screw holes align.
13. Install two socket head screws (5) through aligned holes
of lockplate and into tapped holes of sprocket. Tighten
screws to 90-110 in-lbs (10.2-12.4 Nm).
14. Install the remaining removed components in the reverse
order of the removal procedures. See the procedures
listed in the respective component sections.
15. Adjust drive belt tension. See
in Section 1.
16. Fill transmission to proper level with fresh lubricant. See
CLUTCH, TRANSMISSION FLUID
www.PlanDeGraissage.org
REAR BELT DEFLECTION
in Section 1.
b0249x6x
1 2
1. Main drive gear shaft
2. Transmission sprocket
3. Transmission sprocket
nut (left hand threads)
Figure 6-45. Transmission Sprocket
i00077-
Transmission
Transmission
sprocket
sprocket nut
Line scribed on nut and sprocket
Figure 6-46. Aligning Transmission Sprocket
3
5 4
4. Lockplate
5. Socket head
screw (2)
45
30
6-31