Table of Contents
Advertisement
REMOVAL
1.
See
Figure 2-63.
Loosen seat wing screw (1). Remove
seat by pulling up and back.
2.
Remove two screws (4) and nylon washers (3).
3.
Loosen fuel tank screw (6).
4.
Lift fuel tank (8) and withdraw tail section.
INSTALLATION
1.
Place tail section on frame so mounting holes align with
holes on frame.
2.
See
Figure 2-63.
Install two screws (4) and nylon wash-
ers (3).
3.
Tighten screw (6) to 9-11 ft-lbs (12.2-14.9 Nm).
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
4.
Place seat on tail section. Tighten wing screw.
www.PlanDeGraissage.org
TAIL SECTION
b0217x2x
2
1.
Seat wing screw
2.
Tail section
3.
Nylon washer (2)
4.
Torx screw (2)
4
3
1
5.
Seat
6.
Screw
7.
Washer
8.
Fuel tank
Figure 2-63. Tail Section
5
6
7
8
2-55
Advertisement
Table of Contents
