Table of Contents
Advertisement
VACUUM-OPERATED ELECTRIC SWITCH (V.O.E.S)
ADJUSTMENT/TESTING
See
VACUUM-OPERATED ELECTRIC SWITCH (V.O.E.S)
Section 1.
REMOVAL
1.
Remove seat and fuel tank. See
in Section 4.
2.
See
Figure 7-4.
Disconnect V.O.E.S. connector [P7] from
main wiring harness.
3.
Remove V.O.E.S. from carburetor.
INSTALLATION
1.
See
Figure 7-4.
Place a new V.O.E.S. on carburetor.
2.
Attach V.O.E.S. connector [P7] to main wiring harness.
WARNING
After installing seat, pull upward on front of seat to be
sure it is locked in position. If seat is loose, it could shift
during vehicle operation and startle the rider, causing
loss of control and personal injury.
3.
Install fuel tank and seat. See
TION
in Section 4.
7-10
FUEL TANK, REMOVAL
FUEL TANK, INSTALLA-
www.PlanDeGraissage.org
b0225x7x
in
[P7] WIRE
1
Ignition module
2
Splice number one
Figure 7-4. V.O.E.S. Connector [P7]
TERMINATION
Advertisement
Table of Contents
