Buell S1 Lightning 1996 Manual page 294

INSTALLING SOCKET/PIN
TERMINALS
1. See Figure 7-51. From the secondary lock side of the
connector, insert the terminal into its respective num-
bered chamber until it snaps in place. For proper fit, the
slot in the terminal must face the tang in the chamber.
f1289x2x
Secondary lock open
4
Pin terminal
1
Pin housing
1. Open secondary lock.
2. Insert pick into cavity on mating end of connector.
3. Pivot end of pick to release tang.
4. Gently tug on wire to remove terminal from housing.
www.PlanDeGraissage.org
4
Socket terminal
1
Figure 7-51. Release Tang and Back Out Terminals
2. Gently tug on wire end to verify that the terminal is locked
in place and will not back out of chamber.
3. Rotate the hinged secondary lock inward until tabs fully
engage latches on both sides of connector.
4. Insert the socket housing (plug) into the pin housing
(receptacle) until it snaps in place.
5. Secure wiring harness with new cable straps.
Secondary lock open
Socket housing
2
3
2
Pick tool
3
Pick tool
7-49