Buell S1 Lightning 1996 Manual page 104

REMOVAL
1. See Figure 2-64. Remove two screws and nylon washers
on each side.
2. Detach windscreen from center bracket on tachometer
cover. Remove windscreen.
3. If necessary, remove the three windscreen brackets.
a. See Figure 2-65.
bracket by removing nut on tachometer cover.
b. While holding headlamp, remove left and right head-
lamp adjusting screws (metric). Slide windscreen
brackets from between headlamp housing and
headlamp brackets.
INSTALLATION
1. If removed, install the three windscreen brackets.
a. See Figure 2-65. Install center bracket using nut.
b. Install left and right brackets between headlamp
housing and headlamp brackets. Tighten headlamp
adjusting screws (metric) 6-8 ft-lbs (8.1-10.8 Nm).
2. Align windscreen on right, left and center brackets.
Attach windscreen to center bracket velcro strip.
3. See Figure 2-64. Install two screws and nylon washers
on each side.
2-56
WINDSCREEN
Remove center windscreen
www.PlanDeGraissage.org
5724
Screws and
nylon washers
Figure 2-64. Windscreen, Right Side
5723
1
2
1. Center bracket with
nut and velcro strip
Figure 2-65. Windscreen Brackets
3
2. Right bracket
3. Left bracket