Table of Contents
Advertisement
5.
Check for minimum cam gear end play. See
Record readings.
6.
Remove ignition system. See Section 7.
7.
Place a pan under gearcase to collect oil. Remove cover
screws. Carefully remove gearcase cover. Discard old
gasket (9).
8.
Remove cam gears (1, 2, 3 and 4). Carefully mark each
component to ensure correct installation.
9.
Remove nut (11). Slide pinion gear (5) and oil pump drive
gear (12) off pinion shaft.
CLEANING, INSPECTION
AND REPAIR
1.
Thoroughly clean gearcase compartment, gearcase
cover, and gears in solvent to remove oil and carbon
deposits.
2.
Blow out all cover oil passages and bushings with com-
pressed air.
3.
Clean old gasket material from gearcase and cover faces
with cleaning solvent.
Cam and Pinion Gear Identification,
Inspection, and Selection
See
Figure 3-52.
Cam lobes are stamped with the number "15"
followed by a number (1, 2, 3 or 4). The number "15" indicates
model year application; the number identifies the cam location/
function:
15-1 = rear exhaust
15-2 = rear intake
15-3 = front intake
15-4 = front exhaust
Use only "15" cams on 1996 models.
See
Figure 3-53.
Measure the gear diameter with a microme-
ter over 0.108 in. (2.74 mm) diameter gauge pins on opposite
sides of the gear. The pins are of the proper size to fit
between the contacting surfaces of the gear teeth. Gear
diameter should be measured in at least two places 90
apart. Use
GAUGE PIN SET (Part No. HD-38361)
suring pinion and cam gear sizes.
Cam and pinion gears are individually selected for each spe-
cific gear cover through sophisticated computer-aided mea-
suring techniques in a controlled environment. Each gear is
assigned an individual color code based on its diameter
(measured with gauge pins). When cam and/or pinion gears
are replaced, always use the same color code as found on
gears being replaced to ensure that the gear operation
remains as quiet as possible. For location of cam and pinion
gear color codes, see
Figure 3-54.
www.PlanDeGraissage.org
page
3-46.
2223a
Figure 3-52. Measuring Gear Size
b0096a3x
See
Table 3-9.
each gear with the specifications (listed in inches) shown in
the table to determine amount of wear on gear teeth.
when mea-
Gauge Pin Set
(Part No. HD-38361)
Identify cams by
stamped number
Figure 3-53. Cam Identification
Compare the previously measured diameter of
3-41
Advertisement
Table of Contents
