Buell S1 Lightning 1996 Manual page 285

Left Side
1. Attach switch housing to handlebar with three screws
(metric). Tighten screws to 25-33 in-lbs (2.8-3.7 Nm).
2. See Figure 7-41. Route switch housing wiring harness
between front forks and along right side frame tube.
Attach connector [P6] to wiring harness. Fasten wiring
harness to frame with new cable straps.
3. Install fuel tank and seat. See
TION in Section 4.
WARNING
Check all handlebar switch operations before riding
motorcycle. Handlebar switches not operating properly
could lead to personal injury.
4. Check handlebar switch for proper operation.
7-40
FUEL TANK, INSTALLA-
www.PlanDeGraissage.org
[P6] WIRE TERMINATION
1 Headlamp connector [P4]
2 Splice number nine
3 Splice number three
4 Splice number four
5 Splice number five
6 Turn signal flasher
7 Horn
8 Splice number six
Figure 7-41. Left Handlebar Switch Connection [P6]