Table of Contents
Advertisement
STEP 5
1.
Ignition on.
2.
Momentarily
place screwdriver
black/white and green connector pins.
Since the ignition module ignores the first
four sensor inputs, repeat this step six to
ten times.
3.
Strong evidence of spark at spark plug
when screwdriver is removed. If there is a
spark, sensor is suspect. Install known,
good sensor and test again.
Intermittent Ignition Problem–Vibration
1.
Check battery connections. Disconnect
module ground (scrape paint, add star
washer).
2.
Disconnect white wire at coil terminal
(not module feed).
3.
Connect 16 ga. jumper wire from battery
positive terminal to white wire.
4.
Operate vehicle to see if problem is
eliminated.
Intermittent Ignition Problem–Temperature
1.
Remove outer timing cover.
2.
Remove inner timing cover and gasket.
3.
Start engine.
4.
Spray sensor plate with refrigerant (obtain-
able at electronic supply houses) to see if
engine kills.
5.
With engine hot, at operating temperature
and cover off, apply heat (blow dryer) to
nose of sensor and see if engine kills.
6.
Apply heat (blow dryer) to module and see if
engine kills.
www.PlanDeGraissage.org
b0044a7x
across
A
B
C
A. Red from module
B. Green
C. Black/white pin
b0224x7x
d0018x8x
Sensor
IF NO SPARK
Check module resistance. See
IGNITION RESISTANCE TEST-
IGNITION
MODULE. Replace mod-
ule if resistance is bad.
PROBLEM NOT ELIMINATED
Problem is vibration, possibly loose
connections at safety switches or
defective ignition relay in starter
circuit.
IF ENGINE KILLS
Problem is temperature sensitive
sensor or module. Replace sensor
or module.
7-7
Advertisement
Table of Contents
