Table of Contents
Advertisement
Tail Lamp
1.
See
Figure 7-37.
Install the three tail lamp wires.
2.
See
Figure 7-35.
Attach tail lamp to bracket with two
locknuts (7) (metric) and washers (6).
3.
If removed, install tail lamp bulb.
a.
Turn bulb clockwise to install.
b.
Install tail lamp lens with two screws (1).
WARNING
Check for proper tail lamp and turn signal operation
before riding motorcycle. Visibility is a major concern for
motorcyclists. Failure to have proper lamp operation
could lead to personal injury.
4.
Check tail lamp and turn signals for proper operation.
5.
Use new cable straps to bundle the tail lamp wiring har-
ness under the tail section.
7-36
www.PlanDeGraissage.org
b0230x7x
[P11] WIRE
TERMINATION
1
Splice number four
2
Accessory fuse in fuse block [P9]
3
Splice number five
4
Splice number two
5
Splice number two
6
Rear stoplight switch
7
Unused
8
Splice number two
Figure 7-36. Tail Lamp Connector [P11]
b0246x7x
1.
Black
2.
Orange with white tracer
3.
Red with yellow tracer
Figure 7-37. Tail Lamp Bulb Wires
3
2
1
Advertisement
Table of Contents
