Buell S1 Lightning 1996 Manual page 293

AMP MULTILOCK ELECTRICAL CONNECTORS
REMOVING SOCKET/PIN
TERMINALS
1. If necessary, cut any surrounding cable straps to gain
access to the connector.
2. See Figure 7-50. Depress the button on the socket termi-
nal side of the connector (plug) and pull apart the pin and
socket halves.
3. Bend back the latch slightly and free one side of second-
ary lock, then repeat the step to release the other side.
Rotate the secondary lock outward on hinge to access
terminals in chambers of connector housing.
4. Looking in the terminal side of the connector (opposite
the secondary lock), take note of the cavity next to each
terminal.
Pin terminal
Latch
Pin housing
7-48
Secondary lock open
Socket housing
Figure 7-50. Amp Multilock Connector (Exploded View)
www.PlanDeGraissage.org
5. See Figure 7-51.
insert the pick (Snap-On TT600-3) into the cavity until it
stops. Pivot the end of the pick away from the terminal
and gently tug on wire to pull terminal from chamber. Do
not tug on the wire until the tang is released or the termi-
nal will be difficult to remove. A "click" is heard if the tang
is engaged but then inadvertently released. Repeat the
step without releasing the tang.
Button
Latch
Secondary lock open
With the flat edge against the terminal,
Secondary lock open
Latch
Socket terminal
f1292x2x