Table of Contents
Advertisement
Ignition Circuit
Remove W/BK wire from ignition coil.
Connect a test light or voltmeter to the vehicle.
a.
Attach one end to W/BK wire terminal.
b.
Attach the other end to vehicle ground.
Turn ignition switch to IGN.
Set engine stop switch to RUN.
Place motorcycle in neutral. Is current present?
YES
Place motorcycle in first gear.
Is current present?
NO
Retract side stand.
Is current present?
YES
Extend side stand.
Pull-in clutch lever. Is current present?
YES
Ignition circuit operating properly.
a.
Turn ignition switch to LOCK.
a.
Set engine stop switch to OFF.
b.
Remove test light or voltmeter.
c.
Reconnect W/BK wire to ignition coil.
d.
Remove REAR WHEEL SUPPORT STAND.
www.PlanDeGraissage.org
Check neutral switch and circuit. See
NO
CATOR SWITCH
Repeat entire ignition portion of interlock circuit test
when finished.
Check neutral switch. See
SWITCH
YES
entire ignition portion of interlock circuit test when fin-
ished.
Check side stand switch. See
in Section 7 of the 1996 manual. Repeat entire ignition
NO
portion of interlock circuit test when finished.
Check clutch switch. See
NO
Section 7 of the 1996 manual. Repeat entire ignition
portion of interlock circuit test when finished.
NEUTRAL INDI-
in Section 7 of the 1996 manual.
NEUTRAL INDICATOR
in Section 7 of the 1996 manual. Repeat
STARTER INTERLOCK
STARTER INTERLOCK
in
35
Advertisement
Table of Contents
