How To Program; Programming With Trane Drive Utility (Tdu); Keypad - Trane TR150 Programming Manual

How to Program

2 How to Program
2.1 Programming with Trane Drive Utility
(TDU)
The frequency converter can be programmed from a PC
via RS-485 COM port by using the Trane Drive Utility
(TDU). This software can either be ordered using code
number 130B1000 or downloaded from www.trane.com/
vfd.

2.2 Keypad

The keypad is divided into 4 functional sections.
A. Display
B. Menu key
C. Navigation keys and indicator lights (LEDs)
D. Operation keys and indicator lights (LEDs)
Illustration 2.1 Keypad
A. Display
The LCD-display is back-lit with 2 alphanumeric lines. All
data is displayed on the keypad.
Information can be read from the display.
TR150 Programming Guide
1 Parameter number and name.
2 Parameter value.
3 Set-up number shows the active set-up and the edit set-
up. If the same set-up acts as both active and edit set-up,
only that set-up number is shown (factory setting). When
active and edit set-up differ, both numbers are shown in
the display (set-up 12). The number flashing, indicates the
edit set-up.
4 Motor direction is shown to the bottom left of the display
– indicated by a small arrow pointing either clockwise or
counterclockwise.
5 The triangle indicates if the keypad is in status, quick
menu or main menu.
Table 2.1 Legend to Illustration 2.1
B. Menu key
Press [Menu] to select between status, quick menu or main
menu.
C. Navigation keys and indicator lights (LEDs)
6 Com LED: Flashes when bus communication is communi-
cating.
7 Green LED/On: Control section is working.
8 Yellow LED/Warn.: Indicates a warning.
9 Flashing Red LED/Alarm: Indicates an alarm.
10 [Back]: For moving to the previous step or layer in the
navigation structure
▲
11 [
] [
parameters and within parameters. Can also be used for
setting local reference.
12 [OK]: For selecting a parameter and for accepting changes to
parameter settings
Table 2.2 Legend to Illustration 2.1
D. Operation keys and indicator lights (LEDs)
13 [Hand On]: Starts the motor and enables control of the
frequency converter via the keypad.
NOTICE
Terminal 27 Digital Input (5-12 Terminal 27 Digital
Input) has coast inverse as default setting. This
means that [Hand On] does not start the motor if
there is no 24 V to terminal 27. Connect terminal
12 to terminal 27.
14 [Off/Reset]: Stops the motor (Off). If in alarm mode, the
alarm is reset.
15 [Auto On]: Frequency converter is controlled either via
control terminals or serial communication.
Table 2.3 Legend to Illustration 2.1
BAS-SVP16A-EN - Rev. 2013-09-05
▼
] [►]: For maneuvering between parameter groups,
2 2
9