Trane TR150 Programming Manual page 17

How to Program
Closed Loop Set-up Wizard
Parameter
0-03 Regional Settings
2 2
0-06 GridType
1-00 Configuration Mode
1-10 Motor Construction
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-24 Motor Current
1-25 Motor Nominal Speed
1-26 Motor Cont. Rated Torque
1-29 Automatic Motor Adaption
(AMA)
1-30 Stator Resistance (Rs)
1-37 d-axis Inductance (Ld)
1-39 Motor Poles
1-40 Back EMF at 1000 RPM
16
TR150 Programming Guide
Range
[0] International
[1] US
[0] -[[132] see start -up wizard
for open loop application
[0] Open loop
[3] Closed loop
*[0] Motor construction
[1] PM, non salient SPM
0.09-110 kW
50.0-1000.0 V
20.0-400.0 Hz
0.0 -10000.00 A
100.0-9999.0 RPM
0.1-1000.0
0.000-99.990
0-1000
2-100
10-9000
BAS-SVP16A-EN - Rev. 2013-09-05
Default Function
0
Size selected Select operating mode for restart upon
reconnection of the frequency converter to
mains voltage after power down
0 Change this parameter to Closed loop
[0] Asynchron Setting the parameter value might change
these parameters:
1-01 Motor Control Principle
1-03 Torque Characteristics
1-14 Damping Gain
1-15 Low Speed Filter Time Const
1-16 High Speed Filter Time Const
1-17 Voltage filter time const
1-20 Motor Power
1-22 Motor Voltage
1-23 Motor Frequency
1-25 Motor Nominal Speed
1-26 Motor Cont. Rated Torque
1-30 Stator Resistance (Rs)
1-33 Stator Leakage Reactance (X1)
1-35 Main Reactance (Xh)
1-37 d-axis Inductance (Ld)
1-39 Motor Poles
1-40 Back EMF at 1000 RPM
1-66 Min. Current at Low Speed
1-72 Start Function
1-73 Flying Start
4-19 Max Output Frequency
4-58 Missing Motor Phase Function
Size related Enter motor power from nameplate data
Size related Enter motor voltage from nameplate data
Size related Enter motor frequency from nameplate data
Size related Enter motor current from nameplate data
Size related Enter motor nominal speed from nameplate
data
Size relate This parameter is available only when
1-10 Motor Construction Design is set to [1]
PM, non-salient SPM.
NOTICE
Changing this parameter affects
settings of other parameters
Off Performing an AMA optimizes motor
performance
Size related Set the stator resistance value
Size related Enter the value of the d-axis inductance.
Obtain the value from the permanent magnet
motor data sheet. The de-axis inductance
cannot be found by performing an AMA.
4 Enter the number of motor poles
Size related Line-Line RMS back EMF voltage at 1000 RPM