Trane TR150 Programming Manual page 55

Parameters
8-53 Start Select
Option:
[2] Logic
AND
3 3
[3] Logic OR
*
8-54 Reversing Select
Option:
[0] Digital
*
input
[1] Bus
[2] Logic
AND
[3] Logic OR Activates Reverse command via the serial
8-55 Set-up Select
Option:
[0] Digital
input
[1] Bus
[2] Logic
AND
[3] Logic OR Activate the set-up selection via the serial
*
54
TR150 Programming Guide
Function:
Activates Start command via the serial
communication port, AND additionally via one of
the digital inputs.
Activates Start command via the serial
communication port OR via one of the digital
inputs.
Function:
Select control of the frequency converter reverse
function via the terminals (digital input) and/or
via the serial communication port.
NOTICE
This parameter is active only when
8-01 Control Site is set to [0] Digital and
control word.
Activates Reverse command via a digital input.
Activates Reverse command via the serial
communication port.
Activates Reverse command via the serial
communication port, AND additionally via one of
the digital inputs.
communication port OR via one of the digital
inputs.
Function:
Select control of the frequency converter set-up
selection via the terminals (digital input) and/or
via the serial communication port.
NOTICE
This parameter is active only when
8-01 Control Site is set to [0] Digital and
control word.
Activates the set-up selection via a digital input.
Activates the set-up selection via the serial
communication port.
Activates the set-up selection via the serial
communication port, AND additionally via one of
the digital inputs.
communication port OR via one of the digital
inputs.
8-56 Preset Reference Select
Option:
[0] Digital
input
[1] Bus
[2] Logic
AND
[3] Logic OR
*
3.8.4 8-7* BACnet
8-70 BACnet Device Instance
Range:
1 [0 - 4194303 ] Enter a unique ID number for the BACnet
*
8-72 MS/TP Max Masters
Range:
127 [0 - 127 ] Define the address of the master which holds
*
8-73 MS/TP Max Info Frames
Range:
1 [1 - 65534 ] Define how many info/data frames the device
*
8-74 "I am" Service
Option:
[0] Send at
*
power-up
[1] Continuously
8-75 Intialisation Password
Range:
admin [1 - 1 ] Enter the password needed for execution of
*
BAS-SVP16A-EN - Rev. 2013-09-05
Function:
Select control of the frequency converter Preset
Reference selection via the terminals (digital
input) and/or via the serial communication port.
Activates Preset Reference selection via a digital
input.
Activates Preset Reference selection via the
serial communication port.
Activates Preset Reference selection via the
serial communication port, AND additionally via
one of the digital inputs.
Activates the Preset Reference selection via the
serial communication port OR via one of the
digital inputs.
Function:
device.
Function:
the highest address in this network.
Decreasing this value optimises polling for the
token.
Function:
is allowed to send while holding the token.
Function:
Select whether the device should send the
"I-Am" service message only at power-up or
continuously with an interval of approx. 1
min.
Function:
Drive Re-initialisation.