Trane TR150 Programming Manual page 25

Parameters
0-37 Display Text 1
Range: Function:
[0 - 0 ] In this parameter it is possible to write an individual
text string to be read via serial communication.
Only used when running BACnet.
3 3
0-38 Display Text 2
Range: Function:
[0 - 0 ] In this parameter it is possible to write an individual
text string to be read via serial communication.
Only used when running BACnet.
0-39 Display Text 3
Range: Function:
[0 - 0 ] In this parameter it is possible to write an individual
text string to be read via serial communication.
Only used when running BACnet.
3.1.4 0-4* LCP
Enable, disable and password protect individual keys on
the LCP.
0-40 [Hand on] Key on LCP
Option:
[0] Disabled Select [0] Disabled to avoid accidental start of the
[1] Enabled [Hand On] Key is enabled.
*
0-42 [Auto on] Key on LCP
Option:
[0] Disabled Select [0] Disabled to avoid accidental start of the
[1] Enabled [Auto On] Key is enabled.
*
0-44 [Off/Reset] Key on LCP
Option:
[0] Disabled
[1] Enabled
*
[7] Enable Reset Only
24
TR150 Programming Guide
Function:
frequency converter in Hand Mode.
Function:
frequency converter from keypad.
Function:
3.1.5 0-5* Copy/Save
Copy parameter settings between set-ups and to/from the
keypad.
0-50 LCP Copy
Option:
[0] No copy
*
[1] All to LCP
[2] All from
LCP
[3] Size indep.
from LCP
0-51 Set-up Copy
Option:
[0] No copy
*
[1] Copy from setup
1
[2] Copy from setup
2
[9] Copy from
Factory setup
3.1.6 0-6* Password
0-60 Main Menu Password
Range:
0 [0 - 999 ] Define the password for access to the Main Menu
*
BAS-SVP16A-EN - Rev. 2013-09-05
Function:
Copies all parameters in all set-ups from the
frequency converter memory to the LCP
memory. For service purposes it is
recommended to copy all parameters to the
LCP after commissioning.
Copies all parameters in all set-ups from the
LCP memory to the frequency converter
memory.
Copies only the parameters that are
independent of the motor size. The latter
selection can be used to programme several
frequency converters with the same function
without disturbing motor data which are
already set.
Function:
No function
Copy from setup 1 to setup 2.
Copy from setup 2 to setup 1.
Copy factory setting to programming
setup (selected in 0-11 Programming Set-
up).
Function:
via the [Main Menu] key. Setting value to 0
disables the password-function.