Trane TR150 Programming Manual page 56
Hide thumbs
Also See for TR150:
- Service manual (103 pages) ,
- Programming manual (121 pages) ,
- Quick manual (51 pages)
Table of Contents
Advertisement
Parameters
3.8.5 8-8* FC Port Diagnostics
These parameters are used for monitoring the Bus
communication via the Drive Port.
8-80 Bus Message Count
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of valid
*
telegrams detected on the bus.
8-81 Bus Error Count
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of telegrams
*
with faults (e.g. CRC fault), detected on the
bus.
8-82 Slave Messages Rcvd
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of valid
*
telegrams addressed to the slave, sent by the
frequency converter.
8-83 Slave Error Count
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of error
*
telegrams, which could not be executed by the
frequency converter.
8-84 Slave Messages Sent
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of messages
*
sent from the slave.
8-85 Slave Timeout Errors
Range:
Function:
0
[0 - 65536 ] This parameter shows the number of slave
*
timeout errors.
8-88 Reset FC port Diagnostics
Option:
[0]
Do not reset
*
[1]
Reset counter
3.8.6 8-9* Bus Feedback
8-94 Bus Feedback 1
Range:
Function:
0
[-32768 -
Write a feedback to this parameter via the serial
*
32767 ]
communication port. This parameter must be
selected in 20-00 Feedback 1 Source as a
feedback source. (Hex-value 4000 h corresponds
to 100% feedback/range is ±200%)
TR150 Programming Guide
Function:
BAS-SVP16A-EN - Rev. 2013-09-05
3
3
55
Advertisement
Table of Contents
