Setting The Segment End/Seam End Parameters - DURKOPP ADLER M-TYPE DELTA D887 Operating Instructions Manual

Programming Commander DELTA
Icon Parameter
Parameters Seam End
Sewing stop
Adjustments for seam end bartack parameters
Bartack at seam end
Number of stitches backwards
Number of stitches forward
Operating Instructions D887 - 00.0 - 10/2022
5.8.7.2 Setting the Output parameter
This parameter provides virtual outputs that can be assigned cus-
tomer-specific functions. They can be used when customer-specific
applications require a signal from the control of the machine.
This parameter cannot be used unless the virtual outputs have been
assigned to a physical output at the Technician level. This requires
that the parameter Additional I/O Configuration be configured at the
Technician level; for more details, refer to the explanation in the
 Service Instructions.
5.8.8

Setting the Segment End/Seam End parameters

There are various options for setting the Segment End parameters.
The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Settings
Value range
On/Off
Setting as to what will happen at
the end of a segment/seam.
(see  p. 140)
Value range
On/Off
Value range
1 to 50 [stitches]
Value range
1 to 50 [stitches]
137