Table of Contents
Advertisement
156
7.3
Assembling the stand
Fig. 76: Assembling the stand
①
②
③
④
(1) - Inner bar
(2) - Holder for oil can
(3) - Adjusting wheel
(4) - Stand bar
To assemble the stand:
1.
Screw the cross bar(s)* (7) onto the stand bars (4).
2.
Screw the oil can holder (2) at the rear to the upper cross bar (7).
3.
Screw the cross strut (6) to the foot struts (5).
4.
Insert the inner bars (1) in such a way that the longer end of
the head section (8) is above the longer end of the foot struts (5).
5.
Tighten the inner bars (1) down so that both head sections (8)
are at the same height.
6.
Important: Turn the adjusting wheel (3) so that the stand has
even contact with the ground.
* The stand parts for machines with a long arm have 2 cross
members, other stand parts have 1 cross member.
⑧
⑤
(5) - Foot strut
(6) - Cross strut
(7) - Cross bar
(8) - Head section - inner bar
Operating Instructions D887 - 00.0 - 10/2022
Setup
①
④
⑦
⑤
⑥
Advertisement
Table of Contents
