Setup
Operating Instructions D887 - 00.0 - 10/2022
2.
Fasten the tilt sensor magnet (8) in the slot of the tabletop on
the side ( p. 165).
3.
Screw the oil pan (4) in place under the slot for the machine.
4.
Screw the cable duct (1) to the underside of the tabletop.
5.
Insert the reel stand (7) into the hole.
6.
Assemble the reel stand (7) with nut and washer.
7.
Tighten the thread reel holder and the unwinding bracket on
the reel stand (7) in such a way that they are exactly opposite
each other.
8.
Insert the plug (6) in the hole.
9.
Insert the lower hinge parts into the slots (2).
7.5.2
Assembling the tabletop to the stand
Fig. 79: Assembling the tabletop to the stand
①
②
(1) - Head section
To assemble the tabletop to the stand:
1.
Place the tabletop on the head sections (1) of the inner bars.
2.
Use the screws (2) to fasten the tabletop at the screw holes
of the head sections.
①
②
(2) - Screws
159