Importing/Exporting Programs - DURKOPP ADLER M-TYPE DELTA D887 Operating Instructions Manual

140
5.8.8.1 Setting the Sewing stop parameters
You can set additional parameters for the Sewing stop.
Possible settings and the corresponding value ranges are listed
in the table.
Icon Menu item
Needle up position
Thread trimmer
(can only be set in the last
segment)
Sewing foot lift at segment
end
Height of sewing foot lift
after trim/at segment end
5.9

Importing/exporting programs

Programs cannot be imported or exported by the Default User.
This process requires that the user be logged in as a technician,
 Service Instructions.
Programming Commander DELTA
Setting option
Value range
On/Off
Value range
On/Off
Value range
On/Off
Value range
1 to 20 [mm]
(depending on subclass)
Operating Instructions D887 - 00.0 - 10/2022