Table of Contents
Advertisement
122
Menu item
Software / Stitch
Counter
In Software mode,
the bobbin is
monitored by the
software based on the
number of stitches
sewn.
Programming Commander DELTA
Setting 1
Counter Type
4 different counters can be
applied. The following 3 sub-
items can be set for each of
the counters.
Counter value
Bobbin supply capacity in
stitches. This is a very
variable value, which
depends on the size of the
bobbin and the thickness of
the thread.
Sewing stop
Sewing stops and a notice is
shown on the display when the
bobbin is detected to be nearly
empty. If the parameter is not
activated, only the LEDs on
the machine arm give a
warning if the bobbin is empty.
Sewing foot lower position
Reset necessary
It is only possible to resume
sewing after changing the
bobbin and confirming the
message on the control
panel.
Operating Instructions D887 - 00.0 - 10/2022
Setting 2
Value range
A/B/C/D
Value range
0 to 99999
[stitches]
Value range
On/Off
Value range
On/Off
Value range
On/Off
Advertisement
Table of Contents
