Table of Contents
Advertisement
Programming Commander DELTA
Icon
Parameter
Point position
The distance of the needle from the
material can be adjusted to allow
precise positioning of the sewing
material when starting sewing.
The value entered corresponds to the
degree number on the handwheel.
Flat Sew
Transport correction at zero difference
for Flat Sew.
Material thickness detection
Material thickness detection
Stitch length
Needle thread tension
Sewing foot pressure
Max. Speed
Correction speed effect
Correction speed effect
Operating Instructions D887 - 00.0 - 10/2022
Settings
Value range
0–359 [°]
Value range
-20 to 20
Value range
On/Off
(see p. 126)
The stitch length changes slightly
depending on the material thickness.
For this reason, the stitch length can
be adjusted to different material
thicknesses by the software.
Depending on the material thickness,
the needle thread tension can be
adjusted to different material
thicknesses by the software.
The sewing foot pressure can be
adjusted at different material
thicknesses by the software.
The maximum sewing speed can be
adjusted to different material
thicknesses by the software.
Value range
On/Off
(see p. 129)
119
Advertisement
Table of Contents
