Setting The Segment End Parameters - DURKOPP ADLER M-TYPE DELTA D887 Operating Instructions Manual

Icon Parameter
Sewing foot lift at stop
Height of sewing foot lift
Sewing stop
Light barrier
(optional additional equipment)
The light barrier detects the beginning
and the end of the material. After a signal
was detected, sewing can continue
automatically with the specifically set
parameters.
Icon Parameter
Parameters Seam End
Sewing foot lift after trim
Height of sewing foot lift after trim
Thread trimmer
Bartack at seam end
106
5.6.6

Setting the Segment End parameters

There are various options for setting the Seam End parameters.
The following table lists all possible options.
Settings that are more complex and therefore require further
explanation are described in more detail after the table.
Programming Commander DELTA
Settings
Value range
On/Off
Value range
1 to 20 [mm]
(depending on subclass)
Value range
On/Off
(see  p. 136)
Settings
Value range
On/Off
Value range
1 to 20 [mm]
(depending on subclass)
Value range
On/Off
Value range
On/Off
Operating Instructions D887 - 00.0 - 10/2022