Configure The Uplink Mode - Zte H1600 Maintenance Management Manual

Parameter
Dial Number
MTU
Username/Password
Authentication Type
Connection Mode
Auto-disconnected without traffic
NAT Switch
4. Click Apply button to apply the changes.

4.2.4 Configure the Uplink Mode

Through the combination, WAN, xDSL, LTE can be set as the primary link, the sec-
ondary link and the backup link as required.
Steps
1. On the main page of the ZTE H1600, select Internet > WAN > Uplink Mode to open
the Uplink Mode page, see
Figure 4-11 Uplink Mode Configuration
2. Select the uplink mode, for a description of the parameters, refer to
SJ-20210621164956-008 | 2022-09-01(R1.3)
Description
Dial Number.
Different communication standards have different dial num-
bers.
For example "*99#".
Define the maximum transfer unit.
The Username/Password of new LTE connection.
There are three authentication types:
⚫
Auto
⚫
PAP
⚫
CHAP
There are two connection modes:
⚫
Always On
⚫
On Demand
Setting this parameter when the Connection Mode is On
Demand.
Enable or disable the NAT switch function.
Figure 4-11.
4 Configure the Internet
Table 4-4.
31