Zte H1600 Maintenance Management Manual page 42

ZTE H1600 Maintenance Management Guide
Figure 4-14 IP Filter Page
2. Configure the IP filter configuration parameters, see
Table 4-6 Parameter Descriptions for the IP Filter
Parameter
On/Off
Name
Target
Rule Priority
IP Version
Source IP/Destination IP
Protocol
Ingress
34
Description
Set radiobox On to enable the function of IP filter.
Name of the IP filter item.
The name must be specified.
Specify to discard or permit the data packages.
Specify the value to modify the service priority.
The IP version includes:Any, IPv4 , IPv6.
The source/destination IP address.
Select the protocol that needs to filter packets.
By default, it is Any.
Specify the data traffic direction. The Ingress option and
egress option cannot be the same.
⚫
If the ingress is LAN, the egress should be a WAN or LTE
connection. The data traffic direction is upstream.
⚫
If the ingress is a WAN or LTE connection, the egress
should be the LAN. The data traffic direction is down-
stream.
SJ-20210621164956-008 | 2022-09-01(R1.3)
Table 4-6.