Zte H1600 Maintenance Management Manual page 16

ZTE H1600 Maintenance Management Guide
Table 2-2
Table 2-2 Descriptions of Indicators
LED Indicator
Power
Broadband
(DSL)
Broadband
(WAN)
Internet
2.4GHz
5GHz
WPS
8
describes the indicators on the front panel of the ZTE H1600 unit.
Status
Off
Solid green
Solid red
Off
Solid green
Flashing slowly green
Flashing fast green
Off
Solid green
Off
Solid green
Solid red
Off
Solid green
Off
Solid green
Off
Description
The power supply is not connected or is faulty.
The device is powered on properly.
The device is performing self-detection or the self-detec-
tion fails.
The DSL connection has not been established.
DSL synchronization is normal and the link connection
is normal.
Physical link exists, however carrier wave has not been
detected.
The device is in the handshaking process to establish
the link connection.
The device is not powered on or the WAN port is dis-
abled.
The link is activated.
The device is switched off.
The WAN connection is online. The device has a WAN
IP address from IPCP, DHCP or statically configured.
LED remains green in the case of disconnection due
to idle timeout when PPP dial-on-demand is enabled.
Green LED indicates that the routing connection state is
up.
The WAN connection is dialing up or fails to get online.
Device attempted to become IP connected and failed
(no DHCP response, no PPPoE response, PPP authen-
tication failed, no IP address from IPCP, etc).
2.4GHz WLAN RF switch is off.
2.4GHz WLAN RF switch is on.
5GHz WLAN RF switch is off.
5GHz WLAN RF switch is on.
No WPS access or the WPS access of the terminal ex-
ceeds 2 minutes.
SJ-20210621164956-008 | 2022-09-01(R1.3)