Zte H1600 Maintenance Management Manual page 46

ZTE H1600 Maintenance Management Guide
Figure 4-18 Service Control-IPv6 Page
Table 4-10
Table 4-10 Parameter Descriptions for the Service Control-IPv6
Parameter
On/Off
Name
Target
Ingress
Prefix
Service Type
2. Click Apply button to apply the changes.
Configure the Remote Service Port Control-IPv4
1. Click Remote Service Port Control - IPv4 to open the Remote Service Port Con-
trol - IPv4 page, see
38
lists the Service Control-IPv6 parameters.
Description
Click On to enable the function.
Click Off to disable the function.
Name of the service control item.
The name must be specified.
Specify to discard or permit the data packages.
Specify the data stream inbound direction, and this parameter must
be specified.
⚫
If the Ingress is WAN, all the WAN connection can access ZTE
H1600.
⚫
If the Ingress is LAN, the LAN side can access ZTE H1600.
IPv6 address prefix.
Specify the service that is permitted or denied to access.
Figure 4-19.
SJ-20210621164956-008 | 2022-09-01(R1.3)