Switching Mtr Operation Mode - Tascam Sonicview 16XP Reference Manual

12 - Multitrack Recorder

Switching MTR operation mode

To switch between the three MTR operation modes, when the
MTR is stopped, tap the MTR operation (4) button on the
MULTI TRACK RECORDER Screen.
This will open the MTR operation mode switching menu.
Tap one of the operation mode buttons to switch to that mode
and open an AUTO ROUTING confirmation screen. (See "Using
the AUTO ROUTING function" on page 238.)
Tap the button at the top left to return to the previous screen
without changing the MTR operation mode.
NOTE
i MTR must be stopped to change the MTR operation mode.
The following message will appear if changing the MTR
operation mode is attempted while the MTR is operating.
To change, the MTR must be stopped.
i SOUND CHECK must be "OFF" to change the MTR operation
mode. The following message will appear if changing the
MTR operation mode is attempted while SOUND CHECK is
"ON".
To change, SOUND CHECK must be OFF.
o At least one take is necessary to record in OVERDUB MODE.
For this reason, if the current project has no takes, switching
to OVERDUB MODE will cause the following message to be
shown.
1.
Tap the CREATE button to open the following confirmation
message.
2. Set the Sampling Rate, Bit Depth and File Name Prefix.
240
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
3.
Tap the CREATE button to create a take.
Tap the CANCEL button to open the MULTI TRACK
RECORDER Screen without creating a take.
o If the CANCEL button was tapped in any of the above
confirmation messages
1.
The following message will be shown when switching to
the MULTI TRACK RECORDER Screen or if the MULTI TRACK
RECORDER Screen 0 button is tapped to start recording.
i Tap the CREATE button to open the following
confirmation message.
Set the Sampling Rate, Bit Depth and File Name Prefix,
and tap the CREATE button to create a take and put the
recorder in standby.
i Tapping the CANCEL button on any of the above
confirmation messages will restore it to a stopped
state.
2. Tap the button at the top right of the take list on the
BROWSE MTR Screen to open the following confirmation
message.
i Set the Sampling Rate, Bit Depth and File Name Prefix,
and tap the CREATE button to create a take.
i Tap the CANCEL button to close the confirmation
message without creating a take.