Table of Contents
Advertisement
5 - Routing
OUTPUT PORT SELECT screen
Set output ports for MIX 1–22 and MAIN L/R Master modules on
this screen.
Tap the OUTPUT button on the MODULE (OVERVIEW) Screen or
the Others button on the MODULE (OUTPUT) Screen of these
modules to open this screen. (See "Output routing" on page
115.)
1 LOCK/UNLOCK button
o This button locks/unlocks routing setting change
operations for the unit. This is always locked at the time of
start up.
o When set to "LOCK", tapping an output port selection
button (34) will not change the setting.
o When set to "LOCK", tap this button to open a confirmation
message. Tap the UNLOCK button to close the message
and set it to "UNLOCK". Tapping the CANCEL button on
the confirmation message will close it and maintain the
locked state.
o Tap this button when set to "UNLOCK" to switch it to
"LOCK".
126
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
NOTE
The LOCK/UNLOCK button (1) setting is shared by the
following routing setting screens.
i MODULE (INPUT) Screen
i MODULE (OUTPUT) Screen
i INPUT SOURCE SELECT Screen
i OUTPUT PORT SELECT Screen
i DIRECT OUT PORT SELECT Screen
i INSERT SEND PORT SELECT Screen
i INSERT RETURN PORT SELECT Screen
i TALKBACK INPUT SELECT Screen
i TALKBACK EXT1 DIRECT OUT PORT SELECT Screen
i TALKBACK EXT2 DIRECT OUT PORT SELECT Screen
i MONITOR 1 DIRECT OUT PORT SELECT Screen
i MONITOR 2 DIRECT OUT PORT SELECT Screen
i MONITOR 2 OUTPUT PORT SELECT Screen
2 Output port group page switches
o These show output port group page names.
o Tap a page name to switch to the page with the
corresponding output port group. The name of the
selected page will be highlighted. An * will appear next to
the name of the page that the selected output port is on.
Page name
Contents
ANALOG OUTPUT
Select analog output ports.
Dante
Select built-in Dante output ports.
Select the output ports of the
SLOT 1
expansion card installed in SLOT 1.
Select the output ports of the
SLOT 2
expansion card installed in SLOT 2.
Select USB audio interface output
USB OUT
ports.
3 L/R selection buttons
These select whether to set the output ports of the left or
right channels of stereo modules.
Tap these buttons to switch between left and right. The
selected button will be highlighted.
4 Output port selection buttons
o When the LOCK/UNLOCK button (1) is set to "UNLOCK",
tap these buttons to select output ports. The selected
button will be highlighted light blue. Buttons that cannot
be used will appear dark gray. If a button that cannot be
used is selected, it will appear dark blue.
o For stereo modules, "L" will be shown to the bottom left
of the button selected for the left channel and "R" will be
shown to the bottom right of the button selected for the
right channel.
o If a Dante port that has a mounted SB-16D assigned is
selected, "SB #[ID] [port number]" will be shown.
Advertisement
Table of Contents
