St In 1-2 Module (Overview) Screens - Tascam Sonicview 16XP Reference Manual

6 - Modules
ST IN 1–2 MODULE (OVERVIEW) Screens
ST IN 1–2 module when the input source is ANALOG
1 Metering Point button
o This shows the name of the set metering point.
o Tap this button to open a window for setting metering
points for ST IN 1–2 modules.
Options: INPUT, PRE EQ (default), PRE FADER,
POST FADER
Tap an option to switch the metering point for the level
meter.
NOTE
Metering points can also be changed on the METERING
POINT page of the METER SETUP Screen. (See "METERING
POINT page" on page 41.)
2 Level meters
This shows the level of the signal at the set metering point.
3 MUTE GROUP button
Tap this button to open the DCA/Mute Group SETUP Screen
Mute Group Assign page. (See "Mute Group Assign page" on
page 180.)
4 DCA button
Tap this button to open the DCA/Mute Group SETUP Screen
DCA Assign page. (See "DCA Assign page" on page 179.)
5 MUTE GROUP 1–8 buttons
Tap these buttons to change Mute Group assignment states.
(Default: off )
Assigned buttons will be highlighted.
136
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
6 DCA 1–8 buttons
Tap these buttons to change DCA assignment states.
(Default: off )
Assigned buttons will be highlighted.
7 Snapshot Recall Safe button
Tap this button to enable the Snapshot Recall Safe function
for the selected module. (Default: off )
When this is on, the button will appear highlighted.
NOTE
This can also be set on the MODULE SAFE page of the
SNAPSHOT RECALL SAFE Screen. (See "MODULE SAFE page"
on page 194.)
8 Metering Point position indicator
The highlighted indicator shows the position of the set
metering point.
9 INPUT button
o This shows the input source name. In this case, input
source names will appear split left and right and
abbreviated as follows.
Module name shown
ANALOG
Dante
SLOT 1
SLOT 2
USB IN
ST IN 1
ST IN 2
PLAYER
o If a Dante port that has a mounted SB-16D assigned is
selected, "SB #[ID] [port number]" will be shown.
If it is a virtually-mounted SB-16D,
o Tap this button to open the INPUT SOURCE SELECT
Screen. (See "INPUT SOURCE SELECT screen" on page
118.)
Stereo module name shown
AN
DA
S1
S2
USB
ST1
ST2
PL
will appear.