Making Solo And Built-In Oscillator Settings - Tascam Sonicview 16XP Reference Manual

8 OUTPUT PORT button (MONITOR 2)
o This shows the names of the output ports that the
OUTPUT signal is assigned to.
o Tap this button to open the OUTPUT PORT SELECT Screen
where output ports for the OUTPUT signals can be
selected.
This screen shows the same content as the OUTPUT PORT
SELECT Screen and is operated in the same way.
See "OUTPUT PORT SELECT screen" on page 126 for
details.
button
9
Tap the button to close the additional settings window.
4 - Mixer configuration and settings
Making solo and built-in oscillator
settings
Make solo and built-in oscillator settings on the SOLO/
OSCILLATOR page of the TALKBACK / MONITOR / SOLO / OSC
SETUP screen.
Tap Menu Screen > Mixer Setup > Solo / OSC Setup to open this
screen.
NOTE
This screen can also be opened by pressing either the SOLO
or SOLO CLEAR key while pressing the MENU key. (See "13 -
List of shortcut operations" on page 260.)
1 SOLO MODE buttons
Tap these buttons to set the solo function operation mode.
Option
MIX (default)
EXCLUSIVE
The selected button will be highlighted.
2 SOLO TYPE buttons
Tap these buttons to set the solo function type.
Option
PFL (default)
AFL
The selected button will be highlighted.
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
Meaning
In solo mode, signals from modules that
have their SOLO keys pressed are mixed
for solo monitoring.
In solo mode, only the signal from the
module that had its SOLO key pressed
last is used for solo monitoring.
Meaning
Pre-fader signals are used for solo
monitoring.
Signals after panning (post-fader for the
MAIN L/R Master module) are used for
solo monitoring.
73