Table of Contents
Advertisement
5 - Routing
INSERT RETURN PORT SELECT
screen
Set INSERT RETURN signal input ports for CH 1–40, MIX 1–22 and
MAIN L/R Master modules on this screen.
Tap the RETURN button on the MODULE (OVERVIEW) Screen of
these modules to open this screen. (See "Insert input and output
routing" on page 114.)
1 LOCK/UNLOCK button
o This button locks/unlocks routing setting change
operations for the unit. This is always locked at the time of
start up.
o When set to "LOCK", tapping the input source selection
button (4) will not change settings.
o When set to "LOCK", tap this button to open a confirmation
message. Tap the UNLOCK button to close the message
and set it to "UNLOCK". Tapping the CANCEL button on
the confirmation message will close it and maintain the
locked state.
o Tap this button when set to "UNLOCK" to switch it to
"LOCK".
124
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
NOTE
The LOCK/UNLOCK button (1) setting is shared by the
following routing setting screens.
i MODULE (INPUT) Screen
i MODULE (OUTPUT) Screen
i INPUT SOURCE SELECT Screen
i OUTPUT PORT SELECT Screen
i DIRECT OUT PORT SELECT Screen
i INSERT SEND PORT SELECT Screen
i INSERT RETURN PORT SELECT Screen
i TALKBACK INPUT SELECT Screen
i TALKBACK EXT1 DIRECT OUT PORT SELECT Screen
i TALKBACK EXT2 DIRECT OUT PORT SELECT Screen
i MONITOR 1 DIRECT OUT PORT SELECT Screen
i MONITOR 2 DIRECT OUT PORT SELECT Screen
i MONITOR 2 OUTPUT PORT SELECT Screen
2 Input source group page switches
o These show input source group page names.
o Tap a page name to switch to the page with the
corresponding input source group. The name of the
selected page will be highlighted. An * will appear next to
the name of the page that the selected input source is on.
Page name
Contents
Select analog MIC/LINE input jacks on
ANALOG INPUT
this page.
ST IN
Select the two pairs of ST IN jacks and
the internal memory player.
Player
Dante
Select the built-in Dante inputs.
Select the input ports of the
SLOT 1
expansion card installed in SLOT 1.
Select the input ports of the
SLOT 2
expansion card installed in SLOT 2.
USB IN
Select USB audio interface inputs.
3 L/R selection buttons
These select whether to set the input ports of the left or
right channels of stereo modules.
Tap these buttons to switch between left and right. The
selected button will be highlighted.
Advertisement
Table of Contents
