Table of Contents
Advertisement
4 - Mixer configuration and settings
button
6
o Tap this button, highlighting it, to disable the METER
Screen
(1) and
(7) buttons as shown below and
prevent the METER Screen from being closed.
In this state, the METER Screen will stay open even if the
HOME key on the top of the unit is pressed.
The screen can still be switched, however, by conducting
the following operation.
i Tap the
(5) button to open the METER SETUP
Screen.
i Press the MENU key on the top panel to switch to the
Menu Screen.
i Press the HOME and MENU keys together to open the
LOCK SETUP Screen.
i Press the SEL key on the top panel to switch to the
MODULE Screen.
i Tap the Home Screen NAME area (0) at the bottom of
this screen to open the MODULE (OVERVIEW) Screen.
o Tap the
button when it is highlighted (
confirmation message.
Tap the OK button to end highlighting of the
enabling closing of the METER Screen.
button
7
Tap this button to return to the Home Screen.
NOTE
If the
button (6) on this screen appears highlighted (
), tapping this button will not return to the Home Screen.
8 Page selection buttons
o The button for the currently selected page is highlighted
and corresponding level meters are shown in the meter
area (9).
o Tap one of these buttons to switch to showing the
corresponding level meters.
40
TASCAM Sonicview 16XP/Sonicview 24XP V1.5.0
9 Meter Area
o The level meters are shown for the page with the
highlighted selection button.
Page name
ALL LAYERS
OUTPUTS
LAYER1
LAYER2
LAYER3
LAYER4
LAYER5
LAYER6
LAYER7
o Two meters will be shown for stereo modules.
o Each level meter has an overload indicator at its top. They
will appear to light red when the signal level reaches or
exceeds -0.00026 dBFS (16-bit full-scale value).
o When a level overload occurs, the entire bar meter will
light red.
) to open a
o The area below -60 dBFS at the bottom of the level meters
will light when above -70 dBFS.
0 Home screen name area
o This shows the same information as the NAME area on
the Home Screen for modules assigned to the right
touchscreen on the current layer (module name, user
module name, Mute Group assignment).
o Tap this area to open the MODULE (OVERVIEW) Screen.
(See "MODULE (OVERVIEW) Screen" on page 130.)
button,
Contents
This shows level meters for the
modules assigned to all of the 7 layers
on one line per layer.
User module names (names set by
user) are shown at the bottom of the
level meters.
This shows level meters for MIX 1–22
and MAIN L/R Master modules and
the MONITOR OUT.
The module names, user module
names and metering points are
shown below the level meters.
This shows level meters for
the modules assigned to the
corresponding layer.
The module names, user module
names and metering point names are
shown below the level meters.
Advertisement
Table of Contents
