Ipv4 Static Route - ZyXEL Communications GS1920v2 Series User Manual

IP Application > Static Routing
Fig ure 225
To enable IPv4 static route, configure the static route settings in the
Sta tic Ro ute
35.3 IPv4 Sta tic Ro ute
Click
IP Applic a tio n > Sta tic Ro uting > IPv4 Sta tic Ro ute
shown.
IP Application > Static Routing > IPv4 Static Route
Fig ure 226
The following table describes the related labels you use to create a static route.
Table 148 IP Application > Static Routing > IPv4 Static Route
L ABEL
Active
Name
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Chapter 35 Static Route
screen.
DESC RIPT IO N
This field allows you to activate/deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.
GS1920v2 Series User's Guide
IP Applic a tio n > Sta tic Ro uting > IPv4
in the navigation panel to display the screen as
317