Install The Security Bezel - Lenovo 7X19 Setup Manual

1. Read the safety information and installation guidelines (see
Guidelines" on page
2. Make sure all the removed components are installed, and all the disconnected cables are reconnected.
To install the top cover, complete the following steps:
Step 1. Press and hold on the blue tab of cover release latch; then, rotate the tip of the latch up.
Step 2. Place the top cover on top of the server with both sides aligned.
Step 3. Push the latch down until it clicks in place.
Figure 78. Top cover installation
Demo video
Watch the procedure on YouTube

Install the security bezel

Install the security bezel by pivoting the security bezel inward until the other side clicks into place, and then
locking the security bezel.
Before installing the security bezel:
1. Read the safety information and installation guidelines (see
Guidelines" on page
2. If you have removed the rack handles, reinstall it (see ThinkSystem SR850 Rack Installation Guide).
Step 1. Carefully insert the tabs on the security bezel into the slots on the right rack handle. Then, press
and hold the release latch, and pivot the security bezel inward until the other side clicks into place.
52).
52).
"Safety" on page iii and
"Safety" on page iii and
.
Chapter 3 Server hardware setup
"Installation
"Installation
111