Making Scan Settings Manually - Ricoh IS330DC Operating Instructions Manual

Sending Originals
When scanning with the platen glass,
the following screen appears while
the first page is scanning.
If you press [End Job], the following
screen appears.
3
• If you press [New Job], the original
is scanned using the same scan-
ning conditions as the previously
scanned document, and the desti-
nation and sender settings are also
preserved.
You can continue and use the same
settings, or change the settings as
required, and scan the original as a
separate document. If you set the
original and press the {Start} key,
the original starts scanning as a
separate document.
• If you press [Exit], the display re-
turns to the network delivery scan-
ner's Initial screen, and scanned
data is sent to the delivery server.
❖ ❖ ❖ ❖ Making settings in "Clear settings af-
ter each scan job."
When scanning with the ADF, the
display returns to the network de-
livery scanner's Initial screen once
s c a n n i n g h a s f i n i s h e d , a n d
scanned data is sent to the delivery
server.
40
When scanning with the platen
glass, the following screen appears
while the first page is scanning.
If you press [End Job], the display
returns to the network delivery
s c a n n e r ' s I n i t i a l s c re e n , a n d
scanned data is sent to the delivery
server.
Note
❒ If the {Start} key or [End Job] are
not pressed within 60 seconds,
the scanner finishes scanning,
and the scanned pages are sent
to the delivery server.
Making Scan Settings
Manually
You can select scanning conditions
from the previously set "Manual set-
tings", "User 1", "User 2", and "User 3",
or you can specify your own scanning
conditions.
A
Press [Menu] on the network deliv-
ery scanner screen.
B
With "Manual settings" high-
lighted, press [Settings].
The Settings screen for scanning
conditions is displayed.