Original Orientation And Scan Area Setting - Ricoh IS330DC Operating Instructions Manual

Sending Originals

Original Orientation and Scan Area Setting

If originals are set in an upright ( ) position, you must change the original ori-
entation settings when performing duplex scans.
Reference
For details about how to set the orientation of originals, see P.36 "Sending
Scans".
Scanning One-sided Originals
3
The setting orientation differs depending on whether the width of original is
within or larger than 297 mm (11.7").
Original width
Setting originals on the
platen glass
⇒ P.32 "Setting the Orig-
inal on the Platen Glass"
Setting originals in the
ADF
⇒ P.32 "Setting Originals
in the ADF"
Original orientation set-
tings
⇒ P.36 "Sending Scans"
30
297 mm (11.7") or less
Place the original so that the top
edge touches the top-left of the
platen glass.
Place the top edge of the original
first.
Select
[One-sided].
Note
❒ Because this is the initial val-
ue of this setting, you do not
need to change it.
Wider than 297 mm (11.7")
Place the original so that the top
edge touches the top-left of the
platen glass.
Place the original so that the top
edge is set on the far side of the
ADF tray.
Select
[One-sided].